12-21-2022 10:54 AM
I have configured AD connector and enabled PAM. When going to Privileged Access -> New Privileged Access -> Active Directory, I don't see the AD endpoint listed. I don't see any issue at the endpoint level as under PAM attributes, PAM is set to Enabled.
In the logs, the endpoint count is showing as 0.
12-21-2022 11:59 AM
Do you have workflow added for Emergency Access ID and Emergency Access ID Access Request on respective Security System?
If not make sure you have them added
02-01-2023 01:31 PM
@piyushm Do you still have this issue? Did you verify if the sync jobs are scheduled and running fine? After endpoint gets enabled, it has to get synced via the delta endpoint sync job. Only then the endpoint will show up in the UI. Additionally, like @sk mentioned, Security System should have workflows associated to both the Emergency Access Categories. Without these configurations, endpoint will not show up in UI for access request